.pct-helpers

@@ -10,10 +10,6 @@ CT_DIR=${CT_DIR:=/etc/pve/lxc/}
 # XXX
 
 
-EDITOR=${EDITOR:-vim}
-
-
-
 #----------------------------------------------------------------------
 # XXX this is quite generic, might be a good idea to move this to a 
 # 		seporate lib/file...

bootstrap.sh

@@ -8,9 +8,9 @@ PROXMOX_UTILS=${PROXMOX_UTILS:-https://github.com/flynx/proxmox-utils.git}
 apt update
 apt upgrade
 
-# keep this to the minimum, at this point...
+# keep this to the minimum...
 apt install \
-	git make wget vim
+	git make wget
 
 git clone $PROXMOX_UTILS 
 
@@ -19,5 +19,4 @@ cd proxmox-utils
 make bootstrap
 
 
-
 # vim:set ts=4 sw=4 nowrap :

config.global.example

@@ -28,12 +28,9 @@
 #	LAN_BRIDGE=1
 #	ADMIN_BRIDGE=2
 #
-# NOTE: on a clean Proxmox install ADMIN is pre-setup, we will use it 
-# 	for bootstrapping and reconfigure it later.
-#
-ADMIN_BRIDGE=vmbr0
 WAN_BRIDGE=
 LAN_BRIDGE=
+ADMIN_BRIDGE=
 
 
 # NOTE: it is simpler to statically assign these than to configure dhcp

host/bootstrap-bridges.tpl

@@ -1,17 +0,0 @@
-
-# NOTE: this assumes the ADMIN bridge to exist (proxmox default) and to be vmbr0...
-
-auto vmbr${LAN_BRIDGE}
-iface vmbr${LAN_BRIDGE} inet manual
-        bridge-ports none
-        bridge-stp off
-        bridge-fd 0
-#LAN
-
-auto vmbr${WAN_BRIDGE}
-iface vmbr${WAN_BRIDGE} inet manual
-        bridge-ports ${WAN_PORT}
-        bridge-stp off
-        bridge-fd 0
-#WAN
-

host/make.sh

@@ -19,6 +19,7 @@ need ifreload
 
 readConfig
 
+
 DFL_WAN_PORT=${DFL_WAN_PORT:-enp5s0}
 DFL_ADMIN_PORT=${DFL_ADMIN_PORT:-enp2s0}
 
@@ -35,7 +36,6 @@ SOFTWARE=(
 	tmux
 )
 
-BRIDGES_TPL=bootstrap-bridges.tpl
 
 # XXX
 #readVars
@@ -88,7 +88,7 @@ if xreadYes "# Create bridges?" BRIDGES ; then
 	@ cp "$INTERFACES"{,.new}
 
 	BRIDGES="$(\
-		cat "$BRIDGES_TPL" \
+		cat bridges.tpl \
 			| expandPCTTemplate \
 				LAN_BRIDGE WAN_BRIDGE ADMIN_BRIDGE \
 				WAN_PORT ADMIN_PORT \